Can i check how many hours my Mitras has been operating

[Kasper j.]

Hallo

I have used a bought used Mitras LX 6100-HW. Are there a way to check how many hours the lamp has been operating ? Then I can see if I have to change the LED's to 6300.

Also how old are the lamp. The serial number are 1602074013. Firmware are 1.20.

And one final thing: I think that the lamp has been used in an closed cabinet. There are some salt-spray on it and the hanging fixture looks corrosive/ a bit green. I will do some maintenance. Are there some parts that I should pay special attention to ?

Best regards
Kasper J.

[Thilo]

Hi,

you could check the operation hour meter at the illumination channels in GHL Control Center. If the pre-owner didn't reset them you can see the operation hours there.
The lamp was built in February 2016.

[Kasper j.]

I cant see the operations hours. Is it under the maintenance ? At each channel it says "not involved".

[Thilo]

Oh sorry, this is not supported on the Mitras LX 6...
Then it's unfortunately not possible to see the operation hours.

[Kasper j.]

Ok. I looks like that the lamp has som salt spray and it has been used in an closed cabinet. If I do some maintenance, are there som parts that I should pay special attention to ?

[Vinny]

Take a close look at the LED clusters and look for any signs of water damage.

[Kasper j.]

I did't find any dammage or saltspray on the led pads. But I had to remove the coolingpads from led mainboard in order to clean it. Can I use cooling paste instead of the old cooling pads ? Its the same cooling paste used in a computer on the cpu/fan.