Matthias
08.01.2010, 11:31
Soon we will have detailled instructions for our PAB (ProfiLux Aquatic Bus), in advance here a brief description:
- ensure that all components (ProfiLux3, Expansion Box oder Powerbar) have the newest firmware each
- equip Expansion Box with expansion cards if needed
- wire all PAB-components, order doesn't matter, no ring wiring!
- supply all with power
- ProfiLux 3 has to know all connected devices, this will be done in the menu "System-Configure PAB"
- "PAB group" is 1 as default and needs not be changed if there is only one ProfiLux 3 present on this PAB
- Select "Assign devices", mark all found devices and confirm
- Select "Configure device", choose the powerbar(s) and set up the "start numbering" (Standard 1) or "initial state" (Standard all off); there are no settings to be made for the Expansion Box at present
that's it, thereafter all powerpars should switch correctly and the Expansion Box started to work - it returns sensor values and outputs 1-10V
when devices are removed or added or the equipment of an Expansion Box has been changed then "Assign devices" has to be started again
- ensure that all components (ProfiLux3, Expansion Box oder Powerbar) have the newest firmware each
- equip Expansion Box with expansion cards if needed
- wire all PAB-components, order doesn't matter, no ring wiring!
- supply all with power
- ProfiLux 3 has to know all connected devices, this will be done in the menu "System-Configure PAB"
- "PAB group" is 1 as default and needs not be changed if there is only one ProfiLux 3 present on this PAB
- Select "Assign devices", mark all found devices and confirm
- Select "Configure device", choose the powerbar(s) and set up the "start numbering" (Standard 1) or "initial state" (Standard all off); there are no settings to be made for the Expansion Box at present
that's it, thereafter all powerpars should switch correctly and the Expansion Box started to work - it returns sensor values and outputs 1-10V
when devices are removed or added or the equipment of an Expansion Box has been changed then "Assign devices" has to be started again