Meanwell 60-48P driver and LED control 4

[rholly]

Hi all,
I have a DIY LED setup that I built a while back. It is using the Meanwell 60-48P drivers (I have 6 drivers for 3 channels). Does anyone know if these drivers will work with the LED control 4? I talked with Mike at Rapid LED, and he said that these drivers need 10V PWM signal going out. I have looked on the forums and haven't been able to find out anything, so you help would be appreciated. Also, can I hook 2 drivers up to one channel?

Thanks,
Ryan

[MatthiasF]

Hi Ryan,

there is a thread already, which might help you: https://forum.aquariumcomputer.com/showthread.php?4113-Has-Anyone-attempted-to-connect-Meanwell-ELN-60-48P-drivers-to-an-LED-Control4