myprofilux
13.07.2018, 09:42
Hi,
Updated to the new WiFi-Module-ESP-Update that was released the 12 July 2018. Link here (https://www.aquariumcomputer.com/downloads/wifi-module-esp-update/)
P4 Firmware - 7.14
GCC - 1.x.x.16
Steps:
1. Updated WiFi Module first - Success. New Version showing on GCC:
2. I could not logon to the web interface.
3. I then did a Filesystem flash with the update tool.
4. First time it said it worked - but it didnt, in GCC 1.x.x.16 it showed the File System *(under system > communications> at the bottom) as unchecked.
5. I tried to flash the file system again - this time it worked.
6. Setup all my wifi settings and admin password
Hit the webinterface and tried to login with the credentials I set. (same as the ones I have always had) - did not work.
Then used the default credentials admin - Starfish - it logged me in.....
Closed down GCC, reopened and reconnected went back into the settings removed the password - saved. Updated view, then put in the same password I always use - Save - > tried again same thing wont use my new saved and showing password but will work with the Starfish password.
Have tried rebooting the P4 trying the same thing but it just wont save the new password. It will always work with Starfish. I have updated the WebInterface to 1.06 as well (using the Starfish password to access the site), then tried to reset the password to my default password that I always use - same result as above.
Not to sure what is going on but its not saving new passwords.......
Any ideas - bug?
Updated to the new WiFi-Module-ESP-Update that was released the 12 July 2018. Link here (https://www.aquariumcomputer.com/downloads/wifi-module-esp-update/)
P4 Firmware - 7.14
GCC - 1.x.x.16
Steps:
1. Updated WiFi Module first - Success. New Version showing on GCC:
2. I could not logon to the web interface.
3. I then did a Filesystem flash with the update tool.
4. First time it said it worked - but it didnt, in GCC 1.x.x.16 it showed the File System *(under system > communications> at the bottom) as unchecked.
5. I tried to flash the file system again - this time it worked.
6. Setup all my wifi settings and admin password
Hit the webinterface and tried to login with the credentials I set. (same as the ones I have always had) - did not work.
Then used the default credentials admin - Starfish - it logged me in.....
Closed down GCC, reopened and reconnected went back into the settings removed the password - saved. Updated view, then put in the same password I always use - Save - > tried again same thing wont use my new saved and showing password but will work with the Starfish password.
Have tried rebooting the P4 trying the same thing but it just wont save the new password. It will always work with Starfish. I have updated the WebInterface to 1.06 as well (using the Starfish password to access the site), then tried to reset the password to my default password that I always use - same result as above.
Not to sure what is going on but its not saving new passwords.......
Any ideas - bug?