Line monitor

[Finreef]

Updated P4 to latest firmware and try to get Line monitor port to work.

This is what I have done:

Connected dc 12v plug to Line monitor port, checked that transformer is working and power is on.

Turn on power cut monitoring on from GCC system page (use linemon input)

When I save changes it goes instantly to "power cut" state.

Try this with two tranformers but result was same. What I should try next?

[MatthiasF]

Hello,

our adapter has 5V (not 12V) and it is modified to make sure that the power cut is recognized quickly and not with a longer delay, which may happen due to the capacitors in a standard (not modified) PSU.
And as usual: damages caused by a 3rd party products may not be covered by warranty.

[Finreef]

In manual it says 12v

3.2.8 Power Failure Monitor/ Line Monitor Port A mains voltage monitor (12V plug-in power supply with jack plug) can be connected to this connection.

Where I can find that 5v ghl adapter?

[MatthiasF]

The ProfiLux 4 adapter for power cut monitoring is available in our store:

https://store.aquariumcomputer.com/en/product_info.php?info=p300_profilux-4-adapter-for-power-cut-monitoring.html