bubbling-under
07.01.2010, 00:03
I have been searching threads for info on enabling the Webserver - is this enabled by default on the P3. I can't find any setting to enable so i assume it is !
I can connect to the P3 using IP using Profilux Control Software - however I cannot browse the webserver using HTTP..
I can browse to other devices on my network including router / wireless access point so HTTP must be ok ... now a bit lost for ideas ....
I am also rather limited by my router ( BT Hub ) and it's naff interface - not sure that I can set up port forwarding on it !!! I may have to dig out my old netgear router ...
Any suggestions would be appreciated
I can connect to the P3 using IP using Profilux Control Software - however I cannot browse the webserver using HTTP..
I can browse to other devices on my network including router / wireless access point so HTTP must be ok ... now a bit lost for ideas ....
I am also rather limited by my router ( BT Hub ) and it's naff interface - not sure that I can set up port forwarding on it !!! I may have to dig out my old netgear router ...
Any suggestions would be appreciated