Kimozabe
17.06.2018, 05:53
I’m just about to set up all my equipment which is a lot.
When I read the 5.1 powerbar manual it states that only one powerbar is allowed to be connected when updating firmware. Also in the GCC it states that only the device being updated is allowed to be plugged in so I’m guessing it means unplug lever sensors, leakage sensors etc as well?
It’s ok now because everything is just laying temporarily on a shelf but for future reference:
Do I really need to unplug and plug in each device individually and update? :o
I have 3 powerbars, dozers etc which will be a major pain in the a** to disconnect, move, plug, unplug and set up again.
Also do I need to unplug all sensors, light controller etc?
Kind regards
Kim
When I read the 5.1 powerbar manual it states that only one powerbar is allowed to be connected when updating firmware. Also in the GCC it states that only the device being updated is allowed to be plugged in so I’m guessing it means unplug lever sensors, leakage sensors etc as well?
It’s ok now because everything is just laying temporarily on a shelf but for future reference:
Do I really need to unplug and plug in each device individually and update? :o
I have 3 powerbars, dozers etc which will be a major pain in the a** to disconnect, move, plug, unplug and set up again.
Also do I need to unplug all sensors, light controller etc?
Kind regards
Kim