GHL Logo Yellow

[ispookie666]

I have noticed my GHL doser 2.0(slave), both of them linked to my P3 having Yellow logo - It is NOT blinking yellow.

I have checked the dosing containers, and all of them are more than 90% , there are no warning etc..
Any help?

[Vinny]

The meaning of the color codes can be found here:
https://www.aquariumcomputer.com/what-is-the-meaning-of-the-blink-and-color-codes-of-the-ghl-logo/

Connect to your device and reactivate control when prompted.

[ispookie666]

How do I do that?

[ispookie666]

Any help?

Sent from my SM-N950F using Tapatalk

[Thilo]

Hello,

connect to your ProfiLux 3 with GHL Control Center and a prompt should appear. If not, then try to reset the PAB assignments and assign the PAB devices again.

[ispookie666]

Things I have done.
I have connected it to my P3 via GCC. No prompts appear. The dosers come up on the system as it should. I have rechecked the configuration and numbering. Reassigned the numbering. The dosing schedule is working.
All my dosing containers have more than 70%

I have also removed the dosers and added them again.

I could really do with some help.

[Matthias]

Check first page in GHL Control Center: Is the logo set to "yellow"?

[ispookie666]

Will check when back home.

Sent from my SM-N950F using Tapatalk

[ispookie666]

If I keep it as standard- it is yellow and blue alternating
If I keep it as standard without blinking - it is yellow.

Sent from my SM-N950F using Tapatalk

[Matthias]

so we have a blinking, not a constant yellow

this means there is a warning

check ALL 16 dosing channels, even if not used

make sure that none of the channels has wrong settings

e.g.: switchchannel mode

[ispookie666]

No I believe it's constant yellow.

But if I change the colour to standard- it constantly cycles between blue and yellow.

I only have 7 channels on dosing and they are all fine

Sent from my SM-N950F using Tapatalk

[MatthiasF]

Hello,

did you already try filling up all 16 dosing containers. Even if not used, they are involved when they are set to switch channel mode.

[ispookie666]

Will try this when back home. But my system has only been using 7 channels. The onky thing which has changed is, upgrading to the current Firmware

Sent from my SM-N950F using Tapatalk

[ispookie666]

Oh man MatthiasF - you are a legend

In my dosing channels 8 to 12, it was switch channel, not sure how it got changed to that. I am pretty sure it has got something do with the firmware update as this sytem has been running without any problems for a fair bit of time.

All back to blue