View Full Version : Pump Connections
trigger1121
03.01.2010, 18:40
I am wanting to connect my two powerheads and return pump to my 6D through my Profilux Plus II. Can someone walk me through this? They are not adjustable and don't want to burn the pumps up. I'm running ver 4.0.8.1 if that matters. Thanks
what are you trying to acheve?
trigger1121
03.01.2010, 19:13
I want to connect two powerheads to a channel and my return pump to the other channel. Then during feeding, I want to be able to shut off powerheads, and during maintenance, I want to shut down powerheads and the return. As of right now I have the return assigned to "Current Group 1," and the powerheads assigned to "Current Pump 2." Both modes are set to permanent and with no waves. I guess my only concern is at the bottom, am I just setting the State, Min, Max, and at Night values to 100%?
Ok simply plug powerhead#1 in recepticaSocket#1, powerhead#2 in Socket#2 and return in Socket#3.
now go to System > Socket Function, set:
S1 to Filter
S2 to Filter
S3 to Filter
The Current Groups are used fro the controlable pump like the Tunze 6055, 6105, 6205
trigger1121
03.01.2010, 19:37
Thank you. I just wanted to be sure the current pump table at the bottom of the pumps page was inactive, and that I wasn't trying to give my pumps 80% power.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.