Update P4 from 7.08 to 7.12 fails

[Vega77]

I try to update firmware with gcc1.1.1.3 from 7.08 to 7.12

Theres a quick box that pops up with the text "Please reset the micriocontroller on the userboard. Then press OK button"

Theres a ok buttom to press but after 1 second the dialog box dissapear.

Then after a few seconds "Error: update cant be started! Reset device by disconecting it from power a few seconds"

Tried a power reset on P4 and rebooted pc, but still the same.

After a power reset P4 reboots with firmware 7.08 and seems to be working as it should.

ANy tips for updating it to 7.12 ?

https://youtu.be/izwYFPADUdI

[faltaren]

I always have the same problem. Just do a emergency update. The resetbutton is in the p4. Have to open it

Skickat från min G8141 via Tapatalk

[alekslyse]

You have windows 7. The bootloader drivers that is included is not supporting win7, that's why it fails

[faltaren]

No i have win10. Newest version

Skickat från min G8141 via Tapatalk

[alekslyse]

No i have win10. Newest version

Skickat från min G8141 via Tapatalk

Its was more directed towards the thread starter :) If you have windows 10, did you make sure you have the latest GCC and updated your drivers with the drivers in the "drivers" folder of GCC?

[Vega77]

You have windows 7. The bootloader drivers that is included is not supporting win7, that's why it fails

Thats correct.
I have upgraded P4 now.

[PIWAWT]

For all Win7 users with a Profilux 4, the appendix contains the appropriate driver with an installer for Win7, if it is not needed here either.

10586

regards Pit