HernanAzofeifa
22.03.2018, 16:46
Hi. I have a problem with manual measurement.
The measurement result screen indicates 0.0 dKH
Before making the measurement I start the preparation maintenance process: I press the "Vent Internal Flush" button and then I press the "Flush Measuremnet cell ..." button.
After this, I press the "Start Measurement Now" button
The status box says: "measuring"
Pump # 1 (Sample Water) starts operation, after a while it stops. Pump # 3 (Waste Water) starts operation and after a while it stops. Pump # 1 starts operation again and then stops, again, pump # 3 starts operation and then stops and finally pump #1 starts operation in reverse mode and stops. Pump # 2 (Reagent Fluid) never started operations and The status box changed from "measuring" to "ok" and the result screen remains 0.0 dKH
Any idea?
My firmware is 1.28
Thanks
The measurement result screen indicates 0.0 dKH
Before making the measurement I start the preparation maintenance process: I press the "Vent Internal Flush" button and then I press the "Flush Measuremnet cell ..." button.
After this, I press the "Start Measurement Now" button
The status box says: "measuring"
Pump # 1 (Sample Water) starts operation, after a while it stops. Pump # 3 (Waste Water) starts operation and after a while it stops. Pump # 1 starts operation again and then stops, again, pump # 3 starts operation and then stops and finally pump #1 starts operation in reverse mode and stops. Pump # 2 (Reagent Fluid) never started operations and The status box changed from "measuring" to "ok" and the result screen remains 0.0 dKH
Any idea?
My firmware is 1.28
Thanks