View Full Version : SMS module do not send away alarms from Doser 2, doser 2,1 and KH director
I have problems with two installation of SMS module on two P 3.0 ex network. 1:rst one firmware 6.34 All alarms from probes and levels and other general alarms will be. However alarms from 1 doser 2, one doser 2.1 and KH director only goes to the P 3 but will not been picked up by the sms unit and will not been send out. Firmware all doser 2.x = 1.28 and sms unit = 3.04
The same for one system with P 3.0 ex firmware 6.29 - our doser 2.0 will send alarm to the p# but they are not been picked up of the SMS unit. Its only alarms from these new things that are afected
Sincerely Lasse
Hello,
you mean that alarms of the dosers filling levels and the KH Director measurement are displayed on the ProfiLux 3 screen but aren't been sent per sms module?
Other alarms are displayed on the P3 screen and are sent by sms module?
Yep - thats what I mean
Sincerely Lasse
Do you have the old sms module without PAB or the new version with PAB?
If you have the newer version with PAB, is it connected over RS232 or PAB to your ProfiLux 3?
I´m sorry
I use the PAB version and its connected through PAB. serial 1412067009 and 1106067005
Sincerely Lasse
Ok
and in GHL Control Center you have set "Connection ProfiLux <-> SMS-Modul" to "over PAB"?
Which send condition have you selected?
Its not my first SMS alarm setup. I totally have 5 different P3 network with SMS module. They work all well with all the other things we have alarm on pH, level and other probes. This two network is the only one containing Doser 2/doser2.1 or KH director. On the three other we have the old doser without PAB connection. Have not test the alarm with them. Can do that later on this evening.
As I said in the first post – if we get a pH alarm – everything going as it should and we get a alarm from the SMS unit as alarm, new, But alarms created from doser 2/doser 2.1 and KH director goes to the P3 (an alarm is seen at display) but the SMS unit does not pick it up and send it. The post from Sylvain91 is about exactly the same thing.
Some pictures first network
10395
10396
10397
Sincerely Lasse
Some pictures Second network
10398
10399
10400
The alarm for general alarms is set up the way it should
10401
Sincerely Lasse
Unfortunately, GHL Doser and KH Director aren't supported on the sms-module yet.
If and when the firmware will be adjusted to support their alarms isn't clear yet, because of the many other currently planned projects.
Thank you
If you do a firmware updating of the SMS module - please make its possible to set a delay time for the sending out of any alarms. This because of a lot of very short communication error that show now and than. I have asked for this before because if you run large installations - its a problem.
Sincerely Lasse
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.