Powerbar2Dim

[Morlock]

Hello,

I have a Powerbar2Dim-F/B, how connect it on profilux 3 ?
I try to connect it to S1-S4 port on Profilux (i don't use S1-S4 and S5-S8) and configure the page "switch channels and outlets":
10300
I assigned the number 19 to the first outlets (i have 3 powerbar6D from 1 to 18):
10301
And no working :(

How to connect this Powerbar2Dim-F/B ?
I want to connect my heaters to this powerbar, is it a good idea ?
Is it the same powerbar but with 2 outlets ?
10302

Best regards

[Matthias]

the dimmable powerbar must be connected to an 1-10V intervace (e.g. L1L2), not to a S-port

I hope this wrong connection did not destroy the dimmable powerbar and/or ProfiLux interface

[Morlock]

Thank for your reply, i connected it to L1L2 now and the S1 led is red, what should I still set ?
The profilux is running fine apparently.
What is the clusters near the led on this powerbar ?

[Morlock]

Is there a manual or information on this powerbar ?
I can not find anything even on the official website...