PDA

View Full Version : Recommended KH Director setup



Going Deep
10.02.2018, 14:25
My KHD/2.1 SA Doser comes next week. I am currently using a slave 2.1 connected to my Profilux 4 dosing the triton method. My question is: What is the best setup configuration? The manual covers triton method but want to make my setup can support it. Options:
1. Hook up slave 2.1 to KHD/2.1 SA Doser and not integrate with profilux 4
2. Hook up slave 2.1 and KHD/2.1 SA Doser to profilux 4 via PAB
3. Keep current setup and KHD/2.1 SA Doser as a separate setup
Appreciate any recommendations. Thanks!

Vinny
11.02.2018, 14:26
Hi there,

I think it would be more convenient to have a single connection point rather than two separate ones. For that reason, I would set the D2.1SA to Slave mode, then connect it and the KHD to the P4.

If at anytime your decide to run the KHD and Doser separately, you can easily change the doser back to standalone mode.

WWIIIREEF
12.02.2018, 03:44
Can we still utilize the temp port and level ports on the stand alone dosers while in slave mode?

MatthiasF
12.02.2018, 10:13
Hello,

if Doser is set to Slave mode, it behaves exactly like a Doser Slave and the temperature probe and
level sensors cannot be used through PAB.
In this case, you would use the ProfiLux's own probe and level sensors connections.

Gael
12.02.2018, 10:45
Hi,

Maybe a day it will be possible with a firmware update to use level and temp port of Doser2 Standalone in slave mode (like an expansion box):
10244 10245

Gael