View Full Version : yellow/blue GHL logo
hi,
my doser and KH director logos are flashing yellow/blue,how do i find out what the warning is?
alekslyse
28.01.2018, 19:32
Its from what I know a doser container warning. It can help if you make sure its something in the "containers" that the KH director use. If they are 0 it will flash yellow / blue.
thanks for the reply.
all my doser levels are fine 10194
alekslyse
28.01.2018, 20:01
Check the 4-6 if they might be 0, but running.
how do i check to see if they are running?
alekslyse
28.01.2018, 20:18
how do i check to see if they are running?
Check if any schedule is set, or maybe alarm is checked. Just go though all of them, check the alarm, minimum container, and if your current fluid goes over / under that (remember the pump no 3 is filling a container so you have to be under the alarm, not over). Also check if any of the 4-6 if the calculated dosing is over 0, then a schedule is set.
10195 10197101961019810199looks ok to me not sure if i am missing something
Doser will begin to flash yellow once the fluid container levels drops to 40%.
An explanation of the color codes can be found on our FAQ page
Hi Vinny,
all my are above 60% except the waste water.
10201
Hi,
I noticed I made a typo. :)
I meant to say the logo will begin flashing YELLOW when the level below reaches 40%.
Hi,
I noticed I made a typo. :)
I meant to say the logo will begin flashing YELLOW when the level below reaches 40%.
all my levels seem ok please have a look at my previous post photo
I cant work out what is the problem
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.