ProfiLux Expansion Box 1

[kwiatek]

After Upgrade to 1.09 firmware my temp sensor showing 40 C.
Before I was 1.06 firmware, anybody have that and can share me ?
Or expalin why any update EB1 is fail ?

[Matthias]

did you re-assign the EXB to PAB?

[kwiatek]

Yes

[Matthias]

please post a screenshot of

- System, where the EXB details can be seen
- temperature probe in question, where ADC values can be seen

[kwiatek]

please post a screenshot of

- System, where the EXB details can be seen
- temperature probe in question, where ADC values can be seen

1007010071

[Matthias]

you write
After Upgrade to 1.09 but the screenshot shows 1.08 for the EXB FW

besides this, the ADC-values are wrong, they should be loaded from the EXB after assigning the PAB

so please do this:
1. PAB system reset
2. reboot controller
3. assign again

if the shown firmware version is still not 1.09 do the PAB update again
connect only the EXB during update to PAB

[kwiatek]

you write but the screenshot shows 1.08 for the EXB FW

besides this, the ADC-values are wrong, they should be loaded from the EXB after assigning the PAB

so please do this:
1. PAB system reset
2. reboot controller
3. assign again

if the shown firmware version is still not 1.09 do the PAB update again
connect only the EXB during update to PAB

I will check and let You know


2. reboot controller


You mean restart EB ? or Profilux also ?

[Matthias]

both