View Full Version : Delay after maintenance mode
alekslyse
09.07.2017, 23:36
I made a simple programming logic always on with delayed power on. Is it possible to make sure this works after disabling / exiting maintenance mode. It then ignores the power delay and turn on the socket right away
alekslyse
13.07.2017, 14:01
Nobody knows if that's an error or intended?
keneil01
15.07.2017, 23:03
Im in the same boat. Would love to see delay start on my skimmer after i activate maint mode.
alekslyse
21.07.2017, 23:14
Nothing?
Could you please upload a screenshot of your setup in maintenance and progr. logic?
Which socket is assigned with this logic?
alekslyse
02.08.2017, 19:45
Could you please upload a screenshot of your setup in maintenance and progr. logic?
Which socket is assigned with this logic?
Extremely simple setup, Marc. All off during maintenance, and socket function of the skimmer is set to the attached progr. logic.
9513
9514
After exiting the maintenance mode the sockets just get the inputs of the assigned logic. For example, in your case the input is always on, so the socket would be set to on. The function will be ignored.
Solution:
Set the input of your logic to maintenance and invert it. Then the socket will be delayed on after maintenance.
alekslyse
03.08.2017, 10:01
After exiting the maintenance mode the sockets just get the inputs of the assigned logic. For example, in your case the input is always on, so the socket would be set to on. The function will be ignored.
Solution:
Set the input of your logic to maintenance and invert it. Then the socket will be delayed on after maintenance.
But then it wont be delay when cycling the power regularly?
When do you want the delay exactly be done? After exiting the maintenance mode and?
You can interlace more logics to get this solved.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.