View Full Version : Do action when ph/temp/sg is on a level
alekslyse
05.06.2017, 00:20
How can I do an action based on a probe level. Say I want to run a scrubber if ph is under 8.2? (But not raise an alarm)
Select the socket where you have the scrubber connected and set the function to pH Increase.
alekslyse
05.06.2017, 11:39
Select the socket where you have the scrubber connected and set the function to pH Increase.
Its no possibility to add a number instead of only the increase and decrease function?
I would love to see increase / decrease and a custom number in the programming logic / socket switch so the programming could be more flexible.
You already have the option to set the desired number. It is in the pH probe settings page. Look at nominal value.
You can also use a virtual probe. This is explained in the manual.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.