Do action when ph/temp/sg is on a level

[alekslyse]

How can I do an action based on a probe level. Say I want to run a scrubber if ph is under 8.2? (But not raise an alarm)

[Vinny]

Select the socket where you have the scrubber connected and set the function to pH Increase.

[alekslyse]

Select the socket where you have the scrubber connected and set the function to pH Increase.

Its no possibility to add a number instead of only the increase and decrease function?

I would love to see increase / decrease and a custom number in the programming logic / socket switch so the programming could be more flexible.

[Vinny]

You already have the option to set the desired number. It is in the pH probe settings page. Look at nominal value.

You can also use a virtual probe. This is explained in the manual.