Dose 0.1mL

[bostoncloverleaf]

The GHL website claims that the Doser2 is capable of micro dosing at 0.1mL. I cannot, for the life of me, get it to dose any volume smaller than a full mL.

Am I doing something wrong? I calibrated the specific pump, at a speed of 0, and the gross calibration amount is 5mL per minute.

Thanks

[Vinny]

After setting the speed and calibration, did you enter the amount of fluid that was dispensed?

Settings must be saved after entering the new flow rate of the pump.

[bostoncloverleaf]

Thanks for the reply Vinny. Yes, I clicked the save button after each step of the setup. If I set the volume to be dispensed as 1mL, then it will dose without issue. But, when I try to set up a .3mL dose, of ZeoStart, it will not dose that amount.

[bostoncloverleaf]

So, any suggestions for why the Doser 2 will not dispense anything less than 1mL?