Conductivity card change to salt water

[janvh001]

I have installed an expansion card on the profilux 3.1 for redox and conductivity.
The probe for conductivity says it is for fresh and salt water.
When i want to do the calibration of that conductivity probe, the Value 2 can not be set to for example 50 mS.
Now i found that i have to set the profilux for salt water but i cannot find the setting location in the profilux and not in the control centre.
Firmware version is 6.25.

Any idea where to change this setting in order to calibrate the probe?

[Vinny]

This feature can be found in the Conductivity settings page when you select the Conductivity probe in GCC.

[janvh001]

In GCC there is no feature to change the measurement range or data.
In the Probes/Conductivity tap, I only have the logging and data features.

Does this has something to do because I have the Profilux 3.1T with an extra GHL PLM-CondF-Redox expansion card?

[Gunther]

Have you checked the [ ] Expert view box in GCC?

[janvh001]

Yes, I did. Expert view is on.
Will post some print screens tonight when back at home.

[janvh001]

Here a print screen of the Conductivity tab in GCC

8380

[Gunther]

Reading your posts I found the following unclear ....


I have installed an expansion card on the profilux 3.1 for redox and conductivity.
The probe for conductivity says it is for fresh and salt water.


Does this has something to do because I have the Profilux 3.1T with an extra GHL PLM-CondF-Redox expansion card?

The second post says you have a card for freshwater only (CondF like Freshwater) so a simple question: Which card do you have exactly?
PL-0977 or the PL-0002 or another one?

[janvh001]

That explains a lot... I have the PL-0002. :(
Expansion card I cannot even use (ordered via Sewatec)

By any means you know where to find a PL-0977 in Dubai or UAE?