Mithras 6200

[Clivey]

Hi how can I take out the greens and red led on my Mithras, I currently run them through my ghl profilux 3.1ex and was told I should not have that colour running :confused::confused:

[doggydoc10]

Why take them out? Just lower the control to ZERO!


Always at sea;

Dr. Antonio Longo

[Clivey]

Hi never thought of that one thanks

[Clivey]

Hi I had a look at lowering the greens and reds led today but was un sure how to do, the instruction only came in German
Can you explain
Thanks

[Vinny]

Go to Light Composer and take a look at the section which displays your lighting schedule. Click on each time point and set the red and green LED channels to 0, click apply.

Once you've done that to all your time points, click on "Transmit Illumination Run to all channels", then save your settings.

Tip: Each time you make an adjustment to your lighting schedule, you must click on "Transmit Illumination..." to send the new settings to all LED channels.

83458346

[Clivey]

Hi Viinny how can I check to make sure I've done correct as this was set up for me buy the company I bought lights from, thanks

[Vinny]

You'll know you did it correctly if you go back into the light composer and see that the red and green channels are at 0%.

[Clivey]

Thanks again