monkeyboy
01.01.2016, 17:27
Hi. I have two 6100hv lx.
The one I have as a slave had the usb port ripped from the board whilst I had the lead connected to laptop about 6 months ago.
The screen is also blank but I don't know whether this is coincidal with the damage as I never use the screen and it is pointing away from view into a corner.
Over the holidays I have been tinkering with light projects etc.
When I am in control centre and go on to energy options and say set to 20% there is no dimming on the slave.
I can alter brightnesses through individual channels and the slave will keep with the master.
I have only just noticed this as I have been altering my energy options to see effects on corals.
Tried all the obvious. Reboot lamps, log in and out of control centre etc.
The light works fine but just need to know if it's in same energy options as master.
Any thoughts ?
The one I have as a slave had the usb port ripped from the board whilst I had the lead connected to laptop about 6 months ago.
The screen is also blank but I don't know whether this is coincidal with the damage as I never use the screen and it is pointing away from view into a corner.
Over the holidays I have been tinkering with light projects etc.
When I am in control centre and go on to energy options and say set to 20% there is no dimming on the slave.
I can alter brightnesses through individual channels and the slave will keep with the master.
I have only just noticed this as I have been altering my energy options to see effects on corals.
Tried all the obvious. Reboot lamps, log in and out of control centre etc.
The light works fine but just need to know if it's in same energy options as master.
Any thoughts ?