View Full Version : Maintainence
I have maintainence 1 set to turn a socket on, is there a way I can have this socket on for ten minutes only, then turn on another socket and the other one off just be pressing maint 1.
also, how do I make this socket 12v
I have maintainence 1 set to turn a socket on, is there a way I can have this socket on for ten minutes only, then turn on another socket and the other one off just be pressing maint 1.
also, how do I make this socket 12v
Hello,
sorry but I don't understand this clearly, can you describe it more in detail?
Hello,
sorry but I don't understand this clearly, can you describe it more in detail?
I have maintainence 1 set to turn on a socket when I press maintainence 1 on my touch, I want to plug in a 12v appliance into this socket, first question is, how do I make this socket 12v, and can I only have it on for a set period of time.
Second question, is there a way I can turn on another socket automaticly once the other socket reaches the end of its on time.
Basically I want to run my ro unit to waste for 10 minutes so I can wash out the TDS spike you get on start up, then I want to produce water.
So it's open one 12v solonoid for 10 minutes, close this and open second 12v solonoid to produce ro/di water.
how do I make this socket 12v
12V is not possible.
So it's open one 12v solonoid for 10 minutes, close this and open second 12v solonoid to produce ro/di water.
This is possible with programmable logic, here is an example:
7764
Please try it out before you use it, it is an example and I can't guarantee anything.
You beauty, it works a dream, thank you very much Artur
a little oversight on my part Artur, can I put a time limit on the second socket as well as this is set to stay on atm, once the ro reservoir is full, I need the socket to turn off, this is an hour.
thank you so far
works 100%, thank you very much Artur
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.