View Full Version : How to setup pump programm via profilux 3?
I bought 2 koralia pumps and one GHL Pump Control 1
I connected pump control to profilux to L1L2 socket.
I connected pumps to Pump Control 1
and? What next? How to setup programm I do not understand.
I launched GHL Control Center. And nothing.
Hello,
first you have to setup the L-Ports:
7607
Then you open one of the streampump groups and add the pumps you assigned to the L-port:
7608
We setup Steam Pump 1 and Steam pump 2 to L1L2 port but enable program for Steam Pump1 only?
Right?
You enable the stream pump group and assign stream pump 1 and stream pump 2 to this group.
You can assign the pumps to different groups if you want to use different programs.
I understand
I set up min 5% and max 20% and sinus wave
But pumps does not works. No steam. if I set up max 50% then pumps works but too power.
Sorry but I don't understand what you mean. Can you show me screenshots of your settings?
I mean that if I make settings: minimum=5% and maximum=20% then pump no rotate and not have steam
>>Can you show me screenshots of your settings?
same you screenshot. Just maximum = 20%
Then you maybe should increase the maximum?
Then you maybe should increase the maximum?
if maximum then will be too strong stream
Please show me a screenshot of your 1-10V settings.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.