View Full Version : What's needed to connect DIY led?
I'm looking at adding a DIY led strip to my setup using a dimmable solderless kit from RapidLED.
What would I need to hook this up to my Profilux so I can control them?
If you use a Kit like this (http://www.rapidled.com/06-solderless-led-retrofit-kit-dimmable/), then you need a LFB-AP
Thank you!
There seems to be very little information out there on this part and I don't see it on the GHL website.
I assume the wires from the LED drivers connect to this, and then this connects to the Profilux via a Cat5 cable? Which port?
with a RJ12 Cable to 1-10V Port (L-Port)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.