measurement cell

[myprofilux]

Good day all,

I use to run all my probes in a probe holder I have seen the Profilux measurement cell and this its great however I have read before that certain probes do not like high flow water it would rather have slow flowing water for accurate readings. If this is the case which probes are these or can one run all probes in this measurement cell?

Thanks for the advise

[GHL Support]

In the measurement cell you can operate all sensors that fit into it - but you should take care that the cell is operated as pressureless as possible.

[myprofilux]

In the measurement cell you can operate all sensors that fit into it - but you should take care that the cell is operated as pressureless as possible.

@Carolin my use case for this is to use this on my return line just before it goes into the tank. The flow rate measured by a flow meter is @ 1630l/hr and its a 32mm pipe diameter, would this measurement cell work in that case. Are all the probes safe and give accurate readings at that flow rate?

[Matthias]

yes, this works