PDA

View Full Version : Mitras 6200hv


90reefernyc
14.04.2015, 23:04
What will I need to connect 4 mitras to a profilux P3?
thank you
Jimmy
Monty
15.04.2015, 07:05
You need a PLM PWC wifi communication card and a free slot in your PL3. This has to be inserted in your PL by yourself. But this is really no hassle. After restart the PL recognize the card and you have to do some minor settings on the card itself and on the Metras. Follow instructions in the manuals.

Good luck
Monty


Sent from my iPad using Tapatalk
90reefernyc
15.04.2015, 14:48
You need a PLM PWC wifi communication card and a free slot in your PL3. This has to be inserted in your PL by yourself. But this is really no hassle. After restart the PL recognize the card and you have to do some minor settings on the card itself and on the Metras. Follow instructions in the manuals.

Good luck
Monty


Sent from my iPad using Tapatalk

Thanks Monty
Can I put that card in the PAB if there is no free slots in my P3?
Also I had made my own LED fixtures that are controlled with the P3 with the plm-4L cards is there maybe a wired connection I can do to the p3 and the mitras like I have my LED now?
thanks again
Jimmy
Monty
15.04.2015, 15:52
No, there is no way to connect PLM-PWC anywhere else than in a free slot in the PL3.
And no, there is no hardwire connection possibility from PL to the Mitras.

np
Monty


Sent from my iPad using Tapatalk
90reefernyc
19.04.2015, 19:10
Ok thank you Monty.
Snother question
I just received 3 mitras used. They have the last users settings on them. How do I reset them to factory and start fresh?
But before I do that can I save the settings that are on there now?
Thanks
Jimmy
Monty
19.04.2015, 20:12
After you turn them on (plug in) go in the menu to system and there is the factory reset.
And no, there is no possibility to download the settings.
Anyway, best is to connect them to your PC using GCC via USB and set all your way. Except the energy/output settings high-output or high-efficiency have to be done on the units itself.
Edit: sorry, the master/slave option and slave to master delay options have also be done on the unit.

Sent from my iPad using Tapatalk