The Profilux do its automation magic with: light intensity, water temperature heating and cooling, water circulation intensity, injection of several plant fertilizers, CO2 injection, water change and RO water mixing with carbonate water for water change.
80 liter, 200 x 20 x 20 cm. ! (on my special designed floating wall mount cabinet, with almost all the technical equipment integrated)
Profilux 3 ex
Sensors: Temp, 2 x PH, O2, 2 x mS, Redox
2 x PL-Optolevel
2 x Dosing Unit 4
Profilux Temperature Control 3
Powerbar 4
Profilux View
Several solenoid valves
21 x 3W RGB LED (625nm,530nm,470nm) 3 x 0-10 volt dimmable LED drivers.
500g JBL CO2 system
Jaqno CO2 reactor
50w substrate heater
Deltec 10w T5 UV
3 x Eheim 2213
IKS Aquastar 3000 24v circulation pump (0-10 volt variable)
Best regards from Denmark
Soren
PS. Looking forward to integrate the PAR light sensor head with my unused PLM-ADIN card combined with clever programmable logic for “realtime” light adjustments. Again combined with O2 measurement. If O2 goes to high from plant synthesis (too much light), light turns down in known increments, measured in real time by the PAR light sensor.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-