This is described in the programming guide.
See example:
Example using a pH sensor
Nominal value = 7.0 and Hysteresis = 0.4
The down-regulation-socket switches on at 7.2 and off again at 7.0, the upregulation-socket switches on at 6.8 and off again at 7.0.
It can be seen that the control oscillates by 7.1 or 6.9 and not exactly by the
adjusted nominal value (7.0). This is necessary to allow simultaneous use of upand down-regulation.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks