Hello.
I have a powerbar PAB that no longer works, has searched for it in the GHL computer. Its worked yesterday, has tried to change cable. Is it broken or can it be repaired?
Hello.
I have a powerbar PAB that no longer works, has searched for it in the GHL computer. Its worked yesterday, has tried to change cable. Is it broken or can it be repaired?
check the fuse and use the old cable again.
The fuse is ok
When i use the pAB kabel it alarm in the GHL computer and cant find the powerbar
Skickat från min iPhone med Tapatalk
If you recently attempted a PAB-device update for another device other than the PB5.1, but left the PB5.1 connected, that will cause this problem. The device received the wrong FW.
Please follow the emergency PAB-device update steps as shown here:
https://www.aquariumcomputer.com/kno...r-pab-devices/
Did you take a look at the steps?
The answer to your question is there.
Not yet i Will test as it says
Skickat från min iPhone med Tapatalk
[mention]Vinny [/mention]
Hello now i have Done as it says in the text
In the last step it says
Error while transmitting firmwire.
I have test the both PAB connection
Skickat från min iPhone med Tapatalk
Last edited by wrang; 24.05.2020 at 09:57.
Now i get this error
Skickat från min iPhone med Tapatalk
Make sure you are connected over USB and choosing the "firmware update" button under the PAB-devices section.
NOT the maintenance section.
If issue continues, please open a support ticket and provide these details, screenshots, serial number of your PB and sales reciept.
Bookmarks