Results 1 to 2 of 2

Thread: tranfer settings from profilux 3 eX to 3.1A eX

  1. #1
    Join Date
    21.02.2019
    Posts
    1

    Default tranfer settings from profilux 3 eX to 3.1A eX

    Hello,


    I want to have a back up profilux 3.1A eX ready with al my current settings to replace my 3.1 eX in case of failure.

    However, when I try to put the saved settings from my profilux 3 eX to the profilux 3.1A eX by "transmit from file to profilux" I get an error message: Types of file and device are not compatible! Settings cannot be transmitted!

    error message settings profilux 3.1A eX.jpg

    Is there a way to adjust the settings from the 3 eX so they are compatible with the 3.1A eX?


    Thank you!

  2. #2
    Join Date
    09.11.2017
    Posts
    1,478

    Default

    At first make sure that the firmware versions are the same, then please open a ticket and tell us the serialnumbers of the devices: https://www.aquariumcomputer.com/sup...ets-enquiries/
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •