Unfortunately we recognized after shipping the first few Maxi Doser that the motor tolerances are a bit higher than we expected, so we changed the motor power in firmware 1.26.
I hope you have 1.25 and an update to 1.26 will cure the problem.
1.26 is avaliable for Standalone as well as for Slave in the current GCC.
-> did this work?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks