Hi
the line monitor (power failure) port of the P4 will exactly offer what you need.
You simply plug in there a 5V-12V power supply with 3.5mm plug which gets its power from the AC socket you want to monitor.
P4 recognizes when the voltage on the line monitor port drops, which means that the AC socket has no power also.
You can define what shall happen then, e.g.:
- switch certain sockets off
- change voltage of 1-10V interfaces
- change pump speed
I am not sure if we can manage to have this feature in the first firmware version, if not it will be available in one of the next updates. I am working right now on it.
-> you don't need a PLM-ADIN
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks