I've checked the PAB ressources in the ProfiLux firmware and there were no changes.
So the ProfiLux firmware update has nothing to do with this problem, neither the sensor calibration.
So, I think following was the reason:
If the ressources are changed, the PAB devices need to be reassigned again ... and the saved sensor param file would not match anymore, so the sensor settings need to be made from scratch.
This is also the case, if you add a new card (sensor card for example) in the ExpansionBox or any change on the ExpansionBox sensor settings (Onborad-Sensor enable/disable, Cond F<->S, pH <-> Redox).
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks