For controlling a Mitras Simu Stick you usually need two L-Ports (L1L2 and L3L4, since you have 4 colors available).
If you connect the LED-Control1 to an L-port (e.g. via Y-splitter), then you have to assign an illumination xy to the corresponding 1-10V-interface.
You then have to make the settings as required in the illumination run and that's it.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks