I suggest you have them on one group as it will be easier to manage timing with the pumps.
With one group you put front side of the tank as pump 1 and 3 and the back side pump 2 and 4.
Select permanent opposite and this will make the odd pumps go when the even pumps stop and vice a versa.
You can do the same with 2 groups but not sure if the timing between the two groups will be for each side will be together.
You will also need to change the minimum in the pump speed percentages in the bottom of the page to 0 if you want the pumps to switch on and off. I have also set mine to right angle waves to get the on off scenario you are looking for.
And I don't think GHL are on here over the weekend?
I don't think I have seen them on here then?
Last edited by Antipodes; 08.03.2015 at 21:48.
Call me Paul !
Note: I am not GHL staff!
Bookmarks