These are our settings - with maintenance active and maintenance inactive:
pumps1.jpg
pumps2.jpg
GHL Support Team
These are our settings - with maintenance active and maintenance inactive:
pumps1.jpg
pumps2.jpg
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Benutzer
Hi Carolin,
I tested your config and of course if i set mantainance i see in profilux 1-10 interface that 0v is set on l5 and l6 but only one pump stop i.e. l5 l6 still run as not controlled i.e. at max speed!!!
So setup works even on my profilux but l6 do not react as indicated. The only think is that i have 2 different tunze pump connected one is 6095 and other one is 6105, could that be a problem?
What to do to fix this issue?
Please let me know as it is really bad for me to be forced to use these 2 pumps connected to 2 "L" ports....!
Benutzer
.....any suggestion? ....
GHL Support Team
You have a PM.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Benutzer
....still wait ing some feedback from my config sent
Posting Permissions
Reply With Quote
Bookmarks