Results 1 to 2 of 2

Thread: Nominal temp setting problem

  1. #1
    Join Date
    18.05.2014
    Posts
    1

    Default Nominal temp setting problem

    Hi. I was hoping that you could assist with a problem setting up the Nominal Temperature setting on my Profilux 3, 6.05.

    Currently, my temperature display setting is set to F. The displayed temperature shown correctly in Farenheit, but the Nominal setting entry field still shows Celcius units, followed by F symbol. When I enter the desired nominal temperature, I have to enter the degrees in Celcius. When I tab to another field, the nominal temperature changes to bold letters and now correctly in Farenheit units.
    After I click on SAVE CHANGES, the temp reading in the Nominal Temp entry field reverts to Celcius, followed by letter F.
    The real problem happens when I click on UPDATE VIEW, or close the application thereafter. The nominal setting returns to 32C.
    The net result is that I cannot set my heater. The heater socket function set to Temperature 1, Heater.
    The Power Bar socket will not switch on, unless set to invert. It appears that there could be a software issue?

    Thanks for your kind assistance, Tom

  2. #2
    Join Date
    13.11.2013
    Posts
    1,001

    Default

    Hello,

    which GHL Control Center version do you use? Please try the latest version.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •