I have a PAB bar 6D and I have a small Eheim pump connected to it. I need to see if I can monitor when the pump is not working. Is there a way to program Profilux in order to get an alarm if pump goes bad?
Thanks.
I have a PAB bar 6D and I have a small Eheim pump connected to it. I need to see if I can monitor when the pump is not working. Is there a way to program Profilux in order to get an alarm if pump goes bad?
Thanks.
Unfortunately, this is currently not possible.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Thank you
Is there a reason why I can't see the volts listed like all my other equipment?
Hi Doggydoc,
It is amps you see on the statis page.
But the reason you would not see any current draw, is your pump is only drawing a very small amount and would be below the .1 amp thresshold that the power bar measures.
This monitoring of current flow has been requested a number of times, but they have not addressed this at this time.
Call me Paul !
Note: I am not GHL staff!
Hi antipodes. Thank you very much
That's exactly the answer I was looking for.
Hopefully GHL will address this soon.
Bookmarks