Results 1 to 5 of 5

Thread: PAB Bar issues

  1. #1
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default PAB Bar issues

    I have a PAB bar 6D and I have a small Eheim pump connected to it. I need to see if I can monitor when the pump is not working. Is there a way to program Profilux in order to get an alarm if pump goes bad?
    Thanks.

  2. #2
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    Unfortunately, this is currently not possible.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default

    Thank you
    Is there a reason why I can't see the volts listed like all my other equipment?

  4. #4
    Join Date
    20.02.2009
    Location
    Christchurch
    Posts
    410

    Default

    Hi Doggydoc,
    It is amps you see on the statis page.
    But the reason you would not see any current draw, is your pump is only drawing a very small amount and would be below the .1 amp thresshold that the power bar measures.

    This monitoring of current flow has been requested a number of times, but they have not addressed this at this time.
    Call me Paul !
    Note: I am not GHL staff!

  5. #5
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default

    Hi antipodes. Thank you very much
    That's exactly the answer I was looking for.
    Hopefully GHL will address this soon.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •