Results 1 to 2 of 2

Thread: Profilux Eheim Controller Firmware update

  1. #1
    Join Date
    15.07.2010
    Posts
    43

    Default Profilux Eheim Controller Firmware update

    Hi,

    I apologize for my ignorance but I do not understand how to update firmware Eheim Controller.
    The documentation (in download section) is little confused for me.

    Currently :

    Profilux P3 <-- rs 232 --> Profilux-port of the Profilux Eheim Controller
    PC View <-- rs 232 --> PC View-port of the Profilux Eheim Controller

    What is the correct wiring (step by step) and cables to flash the Profilux Eheim Controller ?

    Thank you...
    Profilux 3 - Tank: 200cm x 50cm x 70cm - Cichlid Malawi

  2. #2
    Join Date
    06.02.2012
    Posts
    2,020

    Default

    What is the correct wiring (step by step) and cables to flash the Profilux Eheim Controller ?
    In general the wiring is clear described [for me]

    1. Remove all cable connections to the EHEIM-Controller.
    2. Connect the EHEIM-Controller directly to a COM (RS232)-port of your PC.
    ...
    THEN connect the connection cable from ProfiLux to the remaining D-Sub interface at the EHEIM-Controller! It is important that you plug in the cable from ProfiLux quickly to avoid a jump start by the update.
    Or in your scheme

    PC-RS232 -----> Eheim-Conroller[*]<-----Profilux
    [*] has to be connected after start of the flasher in less than 2 seconds! Some kind of klick´nplug ....

    Remark: Any other RS232 device like the SMS module or ProfiLux View II has to be removed for update.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •