If the probe shows reasonable values in a glass with tank water or in the calibration fluid, but false values back in the tank,
then the cause could be electromagnetic interferences (defective heater, pump, cable - sometimes ballasts can influence the measurement).
Here we recommend to disconnect all electronic devices one after another and check which device is causing the trouble.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks