Increase the voltage set in the 1-10V interface.
If no go set the off point to 10%, there is little viewable dimming curve below 15% generally
increase the min voltage, e.g. 3V
Hi, i have a little problem with the electronic ballast, my fixture have 2 electronics ballast, only on one, when they start, from 1% to 9% they work well, when they past then 10% the light shut off, and stay off, until a unplug the ballast, if i start the ballast a 20% and higher it work well.
the other one with exact the same setting and voltage, same tube, work well at all %
what ?????
i install your relay to shut off ballast.
Denis
ps, i try to exchange the tube from one ballast to the other and the probleme say to the same ballast.
exact ballast type?
Bookmarks