Results 1 to 4 of 4

Thread: Chiller and Power Bar

  1. #1
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default Chiller and Power Bar

    Quick question guys.
    Have a 3/4 hp Tradewinds Chiller. Will a socket on a 6 was power bar be enough as far as amps is concerned to run it via Profilux? Is there such a thing as a hi voltage power bar?
    Thank you in advance

  2. #2
    Join Date
    23.08.2009
    Posts
    228

    Default

    GHL have the Expansion Socket - 2 sockets 15A HIGH AMP

    I'll pm you a link.

  3. #3
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    each channel of the powerbar can switch up to 15A

    (15A * 110V = 1650W)

    the 15A is also the limit for the total current in the powerbar

    if you need to switch more than 15A by one powerbar you can split the loads with an Expansion Socket:
    https://www.aquariumcomputer.com/en-...xpansionsocket
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  4. #4
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default

    Thank you very much to BOTH!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •