Benutzer
Lights (TL and LED) flash when turned on
Both my TL's (akva stabil, directly connected to L-ports) and my LED RGB-bar (connected to LED4active) flash when turned from off to minimal light setting. With 'flash' I mean go from 'off' to some higher light level and then slowly return to the setting they are supposed to start at.
Any one else has had this experience / knows how to solve?
kind regards,
moose
GHL Support Team
I think you can't change this
the ballasts resp. the drivers need some time to stabilize
only a replacement of these devices could change the behaviour, but I doubt that this is a reasonable option
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Reply With Quote
Bookmarks