Hi,
Meanwell didn't put any information about addittional power on the pwm, but like the meanwell ELN-60-48P (
on the forum and the datasheet didnt mention it... ->
datasheet ELN-60-48P
I have the same problem, and work on the pullout resistor for 3days now :/
I put a power DC12V 300mA on the pullup and 2kohm I get 9.7V and still no control light via profilux (light on but no effect via profilux)... anyway I try to 500ohm to 4.7Kohm still no effect and tension still around 10V :/
I finally try a 47kohm resistor and yes Light on and control via profilux.... any way with the ELN-60-48P in this case I figure out that he need 1.23V to start light...
I go back to my tank room and will give more info when all test and install finish.
Bookmarks