Benutzer
ADIN triggering which feeding pause /maintenance mode?
When coupling the digital inputs 1 to 4 of the ADIN-card to operational modes like feeding pause or maintenance, which of the 4 feeding pauses / maintenance modes do they actually refer to (I cannot enter any more than the operational mode itself, not an additional number)?
GHL Support Team
only Index 1 at the moment
it is planned to make this adjustable in a future firmware release
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Benutzer
Thanks for your response Matthias. Btw: you might want to change the text "Wert" in the Calibration data part of the Probe/sensor controls | Voltage 1 and 2 into "Value" ;-)
GHL Support Team
thanks for the hint - I changed it
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Reply With Quote
Bookmarks