Expansion Box Showing More Sensors Than It Should

[macfishy]

I was playing with the new 6.0 software, love it and I'm looking forward to the final release.

While playing with the software and the hardware I somehow ended up with the software thinking there is twice as many sensors then exists. Its duplicating all the sensors in the expansion box. So when I'm looking at the sensor overview (regardless of what version of software I'm running) I'm seeing sensors that do not exist and have zero balances. How can I remove the sensors from the ghost expansion box that does not exist.

To help explain my playing with software/hardware I have a second Profilux III to play with and test before I actually update the unit running the aquarium.

_macfishy

[GHL Support]

We will take care of your post and will get back to you.

[GHL Support]

Could you remember what you did before the sensors were duplicated?

Perhaps during an assignment the EXB was found twice. Perhaps a loop in PAB?
A PAB reset should help here. After then you have to reassign the EXB (and all other PAB devices) again.
PLC should disconnected after changes on the assignments (and PAB reset) to get the changes.