-
Salinity probe calibration question
I purchased a conductivity/redox card along with a conductivity probe. I followed instructions but used 53.0 mS fluid and took the temperature reading from the fluid and placed it in the display when it was asking for the temp.
I notice the reading is lower on the profilux after calibration, 32.0 ppt while my refractometer is showing 35 ppt. refractometer was calibrated by the same solution
is this reading normal?
-
went ahead and did an offset value
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks